Volkswagen Tiguan Owners Manual: Wheel bolt caps
Fig. 191 Pulling cover caps off wheel bolts.
Read and follow the introductory information and
safety information first⇒
Introduction
to the subject - Take the wire clip out of the vehicle tool kit ⇒ Vehicle tool kit .
- Insert the wire clip through the opening of the cover cap ⇒ Fig. 191 and pull off in the direction of the arrow.
The caps are designed to protect the wheel bolts and should be installed again after the wheel change.
The anti-theft wheel bolt has a separate cap. This only fits the anti-theft wheel bolt, but not the standard wheel bolts.
Wheel cover
Fig. 190 Pulling the wheel cover off.
Read and follow the introductory information and
safety information first⇒Introduction
to the subject Pulling off the wheel cover
Take the lug wrench ...
Changing a wheel
...
See More:
Volkswagen Tiguan Service and Repair Manual > Gears, Shafts: Input Shaft
Overview - Input Shaft
Note
Warm the toothed gear to approximately 100 ºC (212 ºF) using Inductive
Heater -VAS6414-. Wear protective gloves.
Install all input shaft bearings with transmission fluid.
Replace grooved ball bearing after removing.
Circlip
For grooved ball bearing/input sh ...
Volkswagen Tiguan Owners Manual
Volkswagen Tiguan Service and Repair Manual
- Body exterior
- Body Interior
- General Paint Information
- Paint
- Brake System
- Suspension, Wheels, Steering
- Wheel and Tire Guide
- Towing Guide
- Wheel and Tire Guide General Information
- Communication
- Electrical Equipment General Information
- Electrical Equipment from 06/2011
- Heating, Ventilation and Air Conditioning
- Refrigerant R134a Servicing
- 6-Speed Manual Transmission 02Q, OBB, and OFB
© 2018-2024 Copyright www.vwtiguan.org - 0.1035